top of page

RGBX V2 & Xenopixel V2 Instructions Manual

Tip:  Be very gentle when accessing the SD card, the connection of the SD holder (silver sleeve) on the Lightsaber's Electronics board can be fragile and can break if you aren't gentle with it (use tweezers and pull straight up if your fingers can't grab the sd card). 

  1. DON'T SKIP THIS: After each update, reinstall the micro sd card and wait for the 2 "update success" messages. If you don't hear a confirmation message, restore your backup and try the update again.

  2. Update the Micro SD card to 1.7b font fix (attached).

  3. DON'T SKIP THIS: After each update, reinstall the micro sd card and wait for the 2 "update success" messages. If you don't hear a confirmation message, restore your backup and try the update again.

  4. Install the V1.8 update

  5. Reinstall the micro sd card and wait for the 2 "update success" messages. If you don't hear a confirmation message, restore your backup and try the update again.

​

Click the link below to download the Instructions and Files:
Xeno v1.7 Update 

Reach out to us, if you need further assistance and as always...MTFBWY

bottom of page